Aluminum alloy rapid centralized melting furnace introduction

GTM series aluminum alloy rapid centralized melting furnace:

1. The international famous brand bright flame burner uses low excess air coefficient to remove oxygen in the furnace through combustion, so as to reduce the burning loss rate, ensure full combustion and improve thermal efficiency;

2. The structural design is reasonable, the furnace has no dead corner, and it is easy to clean, tidy and maintain;

3. Tower structure, waste heat recovery and reuse of flue gas, low-carbon environmental protection, reduced energy consumption, high thermal efficiency, energy consumption per ton of aluminum melting ≤ 55 × 104kcal/h；

4. The burning loss rate is less than 1.5%;

5. Double temperature control, direct measurement of liquid aluminum temperature, accurate control of liquid aluminum temperature, temperature difference of liquid aluminum ≤± 5 ℃;

6. The furnace lining is made of imported high-quality materials, cast as a whole, with a service life of more than five years, without aluminum, crucible loss and iron hyperplasia;

7. Nano thermal insulation material is adopted, with excellent thermal insulation effect and furnace wall temperature rise ≤ 25 ℃;

8. Automatic feeding, automatic water discharge, full-automatic operation, no need for special personnel to operate. The control system adopts PLC programmable controller, which has stable operation and low failure rate;

9. LPG (liquefied petroleum gas), LNG (natural gas), diesel, cold gas and city gas can be used as fuels;